|
Home > Equipment > Truck-mounted crane manipulators
Medium-power crane manipulator set (CMS) RK 4501V on a model ZIL 5303, MAZ 437040 chassis
Performance series crane manipulators. During development of the new generation of cranes, the chief aims were to improve their ergonomic properties and increase their safety. The following features are original to the new series of cranes: fully built-in electronics, functional protection of the control system and secure layout of hydraulic hoses from the under-frame to the boom. In addition, improvement of some details provides additional crane optimization and functionality, thus making the crane more mobile, fast and maneuverable. In general, these new machines offer much more security and effectiveness. Distinctive features of the Performance Series cranes are the use of wider hexagon bars resistant to lateral torque force, as well as the use of high-pressure and return filters in all of this series' cranes. Like the other PALFINGER series cranes, Performance Class cranes (with their inherited outrigger system) use a return oil utilization system that makes possible a 30% increase in the crane's operation speed. Design of all the Performance Series cranes meets the requirements of the new standard EN 12999, with each of the cranes being painted with water-based, environmentally-friendly paint.
PALFINGER cranes have successfully passed certification tests and have obtained the Certificate of Conformance GOST R No. ROSS AT.MB03.V00065. To zoom into the image, click on the picture.
chassis type |
ZIL 5303; MAZ 437040 |
maximum load moment |
40.0 kNm (4.1 tm) |
maximum boom |
5.2 m up to 12.6 m by customer request |
angle of boom swing |
400 deg. |
load retention valves |
on every hydraulic cylinder |
maximum lift capacity at 1.3 m boom at 3.5 m boom at 5.2 m boom at 7.2 m boom at 9.0 m boom |
2,650 kg 1,040 kg 680 kg 470 kg 360 kg |
ground control, four-section proportional hydro-distributor |
2 consoles on each side |
outriggers |
with manual extending width of 2.9 m, and hydraulic piers (pivotal piers are available by customer request) |
overload protection system |
built-in, with interlocking control levers |
hydraulic reservoir |
built-in, 50 liters with return filter |
high-pressure trunk filter working pressure recommended feeding
|
300 bar 15-25 l/min |
CMS width in folded condition |
0.57 m |
CMS height in folded condition |
1.83 m |
frame mounting size |
0.50 m |
CMS own weight with outriggers |
790 kg |
KOM with hydraulic pump (domestic kit), a set of hoses
vehicle hour counter, inclinometer, installation tools
a set of consumables for 1 year of use
Recommended chassis for mounting: ZIL 5301, ZIL 433360, ZIL 133, MAZ 437040 (low-level)
|
hydraulic actuator for manipulator's jib head to use with attached implements (grapples, etc.);
hydraulic winch;
remote radio control system;
limited system of lift capacity, depending on the crane manipulator's turning angle;
electronic overload protection system with "blackbox" recorder.
outriggers of increased width
Behind the truck cab;
At the truck stern. |
|
|
Search |
|
Services offered to our clients |
|
Services offered to our clients |
|
|